Since 1985 » Simple. Predictable. Profitable.
Overdenture: Brevis™ Abutment
Page 1 | Page 2 | Page 3 | Page 4
Indirect Transfer Technique
 |
 |
 |
 |
 |
 |
1. Rotate a combination of 0 ̊ and/or 15 ̊ angled abutments to achieve parallelism prior to their being seated. Brevis™ abutments are available in heights of 2.0, 4.0 and 6.0mm.
2. Rotate a combination of 0 ̊ and/or 15 ̊ angled abutments to achieve parallelism prior to their being seated. Brevis™ abutments are available in heights of 2.0, 4.0 and 6.0mm.
3. Seat black plastic impression caps onto the Brevis abutments.
4. Make impression using Brevis™ impression caps. Do not make a direct impression of the titanium abutments.
5. Insert the aluminum transfer dies into the impression caps prior to the pouring of a master stone model.
6. Block out undercuts on the model.